!!> Read ➮ Revolution in Manufacturing: Single-minute Exchange of Die System ➲ Author Shigeo Shingo – Dcrjservices.co.uk


  • Hardcover
  • 383 pages
  • Revolution in Manufacturing: Single-minute Exchange of Die System
  • Shigeo Shingo
  • 07 January 2019
  • 0915299038

10 thoughts on “Revolution in Manufacturing: Single-minute Exchange of Die System

  1. says:

    As a lean zealot I know I am supposed to love the works of Shingo He literally wrote the books on SMED and Poke Yoke I have to be honest this book SMED SYSEM was a bit painful to make it through.First section was very good going over the steps involved with separating internal and external setup and justification for setups He explained how to push forandimprovement.Third final section was also very good on implementing boltless methods to reduce setup time Automating bol As a lean zealot I know I am supposed to love the works of Shingo He literally wrote the books on SMED and Poke Yoke I have to be honest this book SMED SYSEM was a bit painful to make it through.First section was very good going over the steps involved with separating internal and external setup and justification for setups He explained how to push forandimprovement.Third final section was also very good on implementing boltless methods to reduce setup time Automating bolt tightening is still very much over processing waste.The middle section, section 2, was the section I was most looking forward to The Case Studies Generally in a book or article I will get the most out of how people implement In this book however, there were so many and they were so technical in nature that many were hard to follow Using pictures usually would help, but in this case the pictures were poor and or the drawings were very technical for someone not familiar with dies Descriptions seemed a bit weak also which I am assuming is due to the translation from the original Japanese to English I would have enjoyed this book muchif the editor had trimmed the case studies down to 2 4 case studies, SMED has 11 case studies The additional 7 or 8 case studies could have been published into a companion book.The techniques are good, there is no doubt, but at over 380 pages 50% being case study it was a tough read that is for sure


  2. says:

    More TPS More Kaizen Great for breaking things down and into simple actions Great supplement to other manufacturing books


Leave a Reply

Your email address will not be published. Required fields are marked *

Revolution in Manufacturing: Single-minute Exchange of Die Systemcharacters Revolution in Manufacturing: Single-minute Exchange of Die System, audiobook Revolution in Manufacturing: Single-minute Exchange of Die System, files book Revolution in Manufacturing: Single-minute Exchange of Die System, today Revolution in Manufacturing: Single-minute Exchange of Die System, Revolution in Manufacturing: Single-minute Exchange of Die System c2b07 Written By The Industrial Engineer Who Developed SMED Single Minute Exchange Of Die For Toyota, A Revolution In Manufacturing Provides A Full Overview Of This Powerful Just In Time Production Tool It Offers The Most Complete And Detailed Instructions Available Anywhere For Transforming A Manufacturing Environment In Ways That Will Speed Up Production And Make Small Lot Inventories Feasible The Author Delves Into Both The Theory And Practice Of The SMED System, Explaining Fundamentals As Well As Techniques For Applying SMED The Critically Acclaimed Text Is Supported With Hundreds Of Illustrations And Photographs, As Well As Twelve Chapter Length Case Studies


About the Author: Shigeo Shingo

Is a well-known author, some of his books are a fascination for readers like in the Revolution in Manufacturing: Single-minute Exchange of Die System book, this is one of the most wanted Shigeo Shingo author readers around the world.